Operation Manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://support.zennio.com
48
 Off Icon and On Icon: dropdown lists for the selection of the icons that will
represent the two states (0 / 1) of the [Pn][Bi] Binary Indicator object,
which gets automatically updated whenever an order is sent through the
control object. It may also receive values from the bus.
b) Binary Control (Text)
Figure 45 Binary Control (Text)
When the user touches the buttons, a binary value will be sent through the
[Pn][Bi] Binary Control object, while the status object, [Pn][Bi] Binary
Indicator, will determine the text that will be shown in the box.
The parameters available are:
 Action: sets the value to be sent on button touches. This can be “Left 0,
Right 1” (default) or “Left 1, Right 0”.
 Text Off and Text On: indicative texts that will be shown in the box
depending on the state (0 / 1) of the [Pn][Bi] Binary Indicator object,
which gets automatically updated whenever an order is sent through the
control object. It may also receive values from the bus.
c) Enumerated Control (Icon)
The box will behave analogously to the case of the Binary control (Icon)
however it will be possible to distinguish up to 6 states (configurable through
the # Enums parameter) instead of only two. The states will be determined by
the reception of any values between 0 and 255, as the control ([Pn][Bi]
Enumerated Control) and the status ([Pn][Bi] Enumerated Indicator) objects
are not binary but 1-byte objects.