Operation Manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://support.zennio.com
46
Note: a list with all the icons available in Z41 can be found in document “Z41
Icon list”, available at www.zennio.com.
c) Scene Control
In this case, the central button of the box will react to user presses by sending
a scene value to the KNX bus through the [General] Scenes: send object,
which is enabled by default. Parameter Scene number permits specifying the
number of the scene (1 – 64) to be sent. Moreover, Action (which shows the
options “Run” and “Run and save”) sets whether the device will only send
scene execution orders (after a short press) or if it will be possible, in addition
to sending execution orders upon short presses, to send scene save orders in
the case of a long press.
Figure 42 Scene control
Finally, the dropdown list next to Button (in the middle) permits selecting an
icon to be displayed inside the button.
Note: a list with all the icons available in Z41 can be found in document “Z41
Icon list”, available at www.zennio.com.
3.4.2.3 2-BUTTON CONTROL
Figure 43 2-button control (Box)
Boxes configured as 2-button controls consist in an indicator and two buttons that,
when touched, trigger the sending of an action to the KNX bus through a certain object.
This category also includes some specific controls such as lighting and shutter
controls.