Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
45
45
Sending of "1" Delay: specify the time, in seconds, after which the value "1" will be sent,
once received the corresponding order.
Periodical sending of "0": define a cyclical sending, in seconds, of the value "0". The
value 0 indicates that the periodical sending is not activated.
Periodical sending of "1": define a cyclical sending, in seconds, of the value "1". The
value 0 indicates that the periodical sending is not activated.
Block: if "Yes" is chosen, a new 1-bit communication object "[Ix] Block" is enabled, to
block or unblock the corresponding input (sending a "1" or a "0", respectively). During the time
the input is blocked, any order received from the KNX bus will be ignored.
Sending statuses on bus voltage recovery: this option allows configuring an automatic
sending of the input status after a voltage recovery, with a sending delay (value between 0
and 255, in seconds).
3.5. THERMOSTATS
InZennio Z38i application offers the possibility to enable and configure up to 2 thermsotats,
independently.
Figure 3.18. Thermostat 1 Configuration
To obtain theoretical information about the Zennio thermostat functioning, as well as information
about its ETS configuration, please consult the specific documentation "Thermostat Zennio"
available at http://www.zennio.com.