Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
44
44
b) Long press
The configuration options are the same as in Short Press.
3.4.2. SWITCH/SENSOR
When configuring an input as switching/sensor, it is necessary to select the action to carry
out in the falling edge and the rising edge.
Figure 3.21. Inputs: Switch/Sensor
The available options are:
Rising edge: select the sending value when this edge happens:
 Nothing (no action is performed).
 0: the object "[Ix] Edge" is sent to the KNX bus with value "0".
 1: the object "[Ix] Edge" is sent to the KNX bus with value "1".
 Switching: sending "0" or "1" to the KNX bus, as appropriate.
Falling edge: select the sending value when this edge happens: Nothing, 0, 1 or
switching.
Sending of "0" Delay: specify the time, in seconds, after which the value "0" will be sent,
once received the corresponding order.