Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
43
43
Note I: The “Stop shutter” configuration include 3 options of step up, step down and switched
step to lamellas control; but if the shutter does not have directional lamellas available, any of
the three options will stop the shutter.
Note II: If the option "up/down (switched)" is chosen to short press, “stop shutter” action will
not be able to be done in any point of the trajectory with other short key press over the same
input.
Dimmer control: this function results on sending to the KNX bus an object for controlling
the Dimmer, which will change depending on the chosen option:
 Light ON: Turn the light ON. The value "1” is sent trough the object “[Ix][Short Press]
Dimmer ON”.
 Light OFF: Turn the light OFF. The value "0” is sent trough the object “[Ix][Short
Press] Dimmer OFF”.
 Light On/Off (Switched): Alternative switching between the ON/OFF orders (to
manage the lighting level with an only input). The values "0” and "1" are sent alternately
trough the object “[Ix][Short Press] Dimmer ON/OFF”.
 Brighter: Every press on the screen increases the lighting level; this parameter
depends on the “Dimming Step” set. A short press reduces the lighting level; a second
press stops the Increase. (See Table 3.1 to know the available dimming steps).
 Darker: Reduces the lighting level with every press on the screen, this parameter
depends on the “Dimming Step” set. A short press reduces the lighting level; a second
press stops the “Reduction”. (See Table 3.1 to know the available dimming steps).
 Brighter/Darker (switched): Alternative Switching between the orders Increase and
Reduce Light level.
Sending of a Scene: This function results on sending the Scene Control Object
"[General] Scenes" to the bus; a scene on the bus may be managed with the input through
this Object.
 Response: Choose whether the scene will be “Run” or “Saved”.
 Scene: This parameter identifies the scene to Run/Save with the corresponding
Input.