Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
41
41
Figure 3.20. Inputs: Push button
Next, the configuration options for the inputs as push buttons are shown. For each of them there are
the following configurable common fields:
Threshold time: this parameter defines the time limit, in tenths of second, where a short
turns into a long press.
Response delay (short press): This parameter sets the time to wait for the object to be
sent to the bus since the action on the input took place. I.e., with a Short Press, for example,
the Z38i panel will wait the established time in "Response Delay (Short Press)" before sending
the corresponding object to the bus. To get an immediate sending (no delay), set the value 0
in this field.
Response delay (long press): This parameter sets the time to wait for the object to be
sent to the bus since the action on the input took place. I.e., with a Short Press, for example,
the Z38i panel will wait the established time in "Response Delay (Long Press)" before sending
the corresponding object to the bus. To get an immediate sending (no delay), set the value 0
in this field.
Block: This parameter uses the object "[Ix] Block". This object will disable/enable the
corresponding input. When receiving the value “1” through this object, the InZennio Z38i will
ignore any pulsation on the input. When receiving the value "0", the input is enabled again.
Note: The actions performed during the block status will not be taken into account when the
input is unblocked.