Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com

 The refresh rate is 1 minute.

 When the display recovers from a bus Power failure, this will show the time it had just

before the incident.

Note I: When a Power bus failure occurs, please have on mind the delay this implies to

correct it.

Note II: There are different KNX devices on the market which can synchronize periodically the

time and date of every single device in the installation. Such devices can be really useful

when the installation is based on any kind of Schedule programming.

BOX 3 (Date setting): This box allows setting the date in the Touch Panel.

To see the date in the display, users only have to press on any of the enabled pages “header”.

The date will be shown during 3 seconds.

Note: The day of the week does not appear on the display; however, when programming the

display, this is automatically configured when setting the date.

BOX 4 (Display contrast setting): The contrast of the panel can be adjusted from this

box. The range for this function lied between 0 and 20. Default value is 12.

BOX 5 (Reset to default values): After a “Reset” in the display, or after a bus failure, the

display will show the same time that it had before these two events.

Note I: It is necessary to press continuously the button for a few seconds to apply the Reset

correctly.

Note II: Take into account that after the reset a few seconds delay could take place respecting

correct time; whereas after a bus failure this delay can be much bigger (it depends on the

duration of the bus failure).

This is the aspect the configuration page shows: