Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
33
33
 BOX 1 (On/Off): This box is enabled in the Climate page to send the orders to switch
on/switch off the climate system connected to the KNX bus. The communication objects
related to the switching on/off pf the system are enabled ("On/Off
Sending" and "On/Off Reception"). Moreover, a new 1 bit object appears: "Activity
indicator" to be associated, through a same group address, to the 1-bit control variables
of the climate system. So that, when the control variable of the climate system sends the
value "1", an indicator will start blinking in the right upper side of the ON indicator in the
first box of the climate page (see figure 2.10). When this object is "0" (because the 1-bit
control variable is "0"), the indicator stops blinking. This allows knowing at all times when
the climate system is in the "0" cycle (heating/cooling source off) or in the "1" cycle
(heating/cooling source on), which may be useful, for instance, to know when the hating
of a house is on and when it is off.
Figure 3.16. Activity indicator ON
 BOX 2 (Setpoint temperature): By enabling this box, the temperature of the climate
system can be controlled and monitored, depending on the parameterized method to set
the setpoint.
Once this temperature is fixed and the system turned on, the established value will be
considered as the setpoint to be kept by the system.
This setpoint value can be established in two different ways:
 Float-point object: the desired setpoint temperature can be controlled in two
different ways (“Control Type”), but always through a 2-bytes communication object 2
“[Clima x] Setpoint Sending”: