Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com

The way to parameterize any of the 5 boxes of a Specific Page to control scenes is exactly the

same as that described in section 3.3.1. Scene control. To obtain further information on this

topic, please read the corresponding section.

Timers

The daily/weekly programming of certain events the user wants them to happen on the KNX

installation is much easier using this Page.

Figure 3.13. Specific page: Timers

The Timers are associated to the On/Off of the devices in the KNX installation, and any

specific page enabled to scenes control will have available four boxes (each enabled page) to

this purpose.

Figure 3.14. Timer page with its 4 boxes configured

Function Modify the

selected element:

- Increase the

Hour/Minute

- Change the sent

value/s (On/Off)

- Check/Uncheck

Weekdays

SET

Function Select

element:

- Hours

- Minutes

- Sent value (On/Off)

- Weekdays