Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com

The parameters to be configured are:

 Starting/Finish time: to establish the time (hours and minutes) when the presence

simulation will start and finish (provided that the functionality has been enabled through

the object "[Home x; Box y] Presence simulation").

Note: The stating and the finish time must be different values in order to the presence

simulation work properly.

 Minimum/Maximum ON/OFF time: To adjust by parameter the minimum and

maximum ON/OFF time for the devices on the installation.

Note: The value established for Maximum Time (both ON and OFF) must be greater than

the value established for Minimum Time, in order not to generate a wrong

parameterization that may cause anomalous situations.

3.3.2. SPECIFIC PAGES

Z38i has 4 specific pages of free configuration, to be parameterized as: Scenes, Timers or

Climate.

Next, all of them are explained in detail.

Scenes

Two pages are available (“HOME” and “HOME 2”) where there is the possibility to configure

one or several boxes to scenes control.

Figure 3.12. Specific page: Scenes