Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
20
20
on the buttons), where depending on the “dimming step” set, keeping the button
pressed will reduce or increase the brightness on the controlled lamps.
Dimming step: Seven different regulation levels are available for this duty. A long
press on the display buttons will reduce or increase the brightness level step by step
the percentage set in this parameter; once the desired level is reached, stop pressing
the button on the display to keep the desired value. To know the available dimming
steps, please see Table 3.1.
 Precise dimming (1 byte): This is the most accurate control method, as any
short press on the display buttons will increase or reduce (1%) the brightness level. A
long press on any of the two buttons will increase or reduce gradually 10 % the
brightness level.
 Indicator: it will inform about the brightness percentage applied at any time.
Note: In this case, for this indicator to be functional, it is necessary to use a KNX dimmer
to give back the brightness applied to the load.
Dimming step
Necessary pulsations for a complete
regulation (0-100%)
(1) 100%
1
(2) 50%
2
(3) 25%
4
(4) 12.5%
8
(5) 6.25%
16
(6) 3.1%
32
(7) 1.5%
64
Table 3.1. Dimming step
Shutter control: Specifically designed to control any type of shutters, blinds, sun blinds,
or any other drive. Through the communication objects "[Home x; Box y] Move shutter" and
"[Home x; Box y] Stop shutter", it will be possible to raise/lower shutters and even knowing its
exact position at any time (if the corresponding indicator is enabled). There will be two buttons
in the box, one for lowering/stopping the shutter and other for rising/stopping it.