Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
18
18
Figure 3.11. Example of configuration of Home page
Next, all the possible configurations for the Home and Home 2 boxes are explained.
Note: For all the options shown below it is possible to configure, through the parameter Icon, the
icon or pair of icons that will be drawn, pixel by pixel, over the representation of each button in the
display. To know the list of available icons, please consult the specific documentation "List of
controls and indicators".
Binary control: allows the panel to communicate with the rest of the devices of the
installation, by sending a binary value ("0" or "1") through the object "[Home x; Box y] Binary
Control". The following options will appear:
 Button 1 (always enabled): to configure the actions associated to a short press and
to a long press over the button, as well as the associated icon. The actions of every type
of press can be:
 Nothing
 0: sending of the value "0" to the KNX bus through the corresponding object
every time the button 1 is pressed (short or long press).
 1: sending of the value "1" to the KNX bus through the corresponding object
every time the button 1 is pressed (short or long press).
INDICATOR