Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com

Figure 3.5. Remote control options

 Zone 1: To enable and associate this IR controller zone to any of the Home or Home

2 pages.

 Zone 2: To enable and associate this IR controller zone to any of the Home or Home

2 pages.

Note: If remote controller is disabled in the parameterization, a press key over any button

DOES NOT have effect in the touch panel.

Internal Temp. Sensor: Z38i counts on an internal temperature sensor that has a 2-byte

communication object associated "[General] Temperature", enabled by default.

Figure 3.6. Internal Temperature Sensor

The following parameters can be configured:

 Temperature sensor calibration: this option allows calibrating (the setting the

tenths of degree) a possible deviation between the measurement made by the sensor and

the real temperature of the room.

 Temperature sending period: to select by parameter the time (in tens of second) to

send cyclically to the KNX bus the current temperature measurement, through the

communication object "[General] Temperature". The value 0 indicates that the periodical

sending is disabled.

Password: With this option, it will be possible to configure a customizable password, by

establishing 4 digits from 0 to 9, which must be written to access those pages on which

security was enabled.