Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
12
12
3.2. GENERAL
The General window allows enabling and configuring the basic functionalities of the panel
and the remote control.
The basic functions that can be configured in the section General are the following:
Display lighting: This function allows establishing the luminosity status of the display, by
parameter, choosing between:
 Always lighting: the display remains always ON, even when the it is not in use.
 Automatic luminosity attenuation: 45 seconds after the last interaction on the
display, this will recover its stand-by mode. These options are shown:
 Luminosity attenuation level: to choose the option Completely dark (after the
corresponding 45 seconds, the Display will remain off) or the option Low luminosity
(after the corresponding 45 seconds, the display will light slightly, which may be
useful to identify the panel in dark places).
 Status during attenuation: to choose the option Display enabled (the display
remains always active; this means that any interaction with it will obtain an immediate
response) or the option Display disabled (the display needs a first touch over it to be
unlocked; after this, the panel can be normally operated).
Figure 3.3. Lighting options
Startup indicators update: This function allows that, after a bus power failure, the value
of the indicator objects is updated (those with the updating flag "U") by sending Read
messages to the external devices connected to the KNX bus that have the reading flag "R".
Moreover, this functionality allows establishing a delay for sending the initial values since the
power is recovered (to get an immediate sending, set 0 in the field "Delay").