Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA vwww.zennio.com
10
10
3. ETS PARAMETERIZATION
For starting to parameterize the Z38i touch panel it is necessary, once the ETS program has
been opened, importing the data base of the product (version 2.2 of the application program
InZennio Z38i).
Next, the device is added to the project where desired. Click the right mouse button on the device
and select "Edit parameters" for starting with the configuration.
In the following sections there is a detailed explanation about each of the different functionalities of
the application in ETS.
3.1. DEFAULT CONFIGURATION
This section shows the default configuration from which the device parameterization starts.
Figure 3.1. Default topology
In the figure 3.1, the default communication objects are shown: "[General] Time" and "[General]
Date" show the current time and date, respectively; also the scenes object: "[General] Scenes", a 2-
bytes object that shows the real temperature of the room, measured by the internal sensor of Z38i
("[General] Temperature") and the objects "[General] Display lighting" and "[General] Touch block",
which allow interacting with the panel (when receiving the value "1" through the first one, the Display
will light up -if it was off- and when receiving the value "1" through the second one, the Display will
be blocked).
When entering for the first time to the parameters edition of Z38i, the following window will be
shown: