Installation Guide

10
1-800-892-3986 IS19172-I2
Step 6 - Permanent Installation
• PERSON 1: While facing the tub, press the rod (A) rmly against the left side.
• PERSON 2: Press the rod (B) rmly on the right side and secure the length of the rod by tightening the
set screws (F) on the rod with the allen wrench (E).
RECOMMEND
Step 7 - Permanent Installation
• PERSON 2: Twist the tube assembly so the rod tightens rmly against the wall.
• Once the rod assembly is secure, twist the tube until tight.
• NOTE: After tightening the rod fully, insert the set screw cap (G) into the screws on the underside of rod.
RECOMMEND
B
B
PUSH
PUSH
4
Person 2 tightens
end of rod B.
5
FINAL
STEP
Person 1
(LEFT)
Person 2
(RIGHT)
Extend rod fully and apply outward pressure.
Person 2 (RIGHT) tightens screws fully.
F
Tighten screws
on bottom.
TOP B
B
PUSH AGA
INST
F LOO
R
A
B
E
B
B
PUSH
PUSH
4
Person 2 tightens
end of rod B.
5
FINAL
STEP
Person 1
(LEFT)
Person 2
(RIGHT)
Extend rod fully and apply outward pressure.
Person 2 (RIGHT) tightens screws fully.
F
Tighten screws
on bottom.
TOP B
B
PUSH AGA
INST
F LOO
R
G