Instructions / Assembly

Pg 15 of 32

www.zennahome.com IS072D2-I

Tension Mount Installation

• Measure the space between the walls of the bathtub or shower where your rod assembly will be installed.

• NOTE: Please write down your measurement below, you will need this later.

• NOTE: ASSEMBLE ON A SMOOTH FLAT SURFACE.

• On the 7/8 in. diameter tube assemblies (C), twist the tube in the direction of the arrow sticker by 2 turns,

making the assembly longer, fig 1.

• Now, extend the rod assembly to the measurement from step 4 and lock the length of the assembly

with the rod set screws (4) using the small hex wrench (6). NOTE: Tighten the rod set screws (4) until it is

flush with the rods, fig 2.

Step 4 - Measure the space between the walls.

Measurement

between walls:

Step 5 - Extending the 7/8 in. Rod and installing the Set Screw.

rod assembly

Fig. 1

Fig. 2

twist the tubes

in the direction of the

ARROW STICKER