Service manual

4-2

DECK MECHANISM DISASSEMBLY

(S3)

(S2)

(S3)

(A)

Stator

Carbon Brush

Drum Motor

Rotor

Drum Sub Assembly

FPC Drum

(S1)

FPC Holder

1. Drum Assembly (Fig. A-1-1)

1) Unplug the FPC Drum Connector.

2) Remove three Screws (S1) on the bottom side and sep-

arate the Drum assembly.

3) Unhook (H1), (H2) and separate the FPC Holder and

FPC Cap. (See Fig. B-1)

1-1. Drum Motor

1) Remove two Screws (S2) and disassemble the Stator of

the Drum Motor.

(2) Remove two Screws (S3) and separate the Rotor of the

Drum Motor from the Drum Sub assembly.

When reassembling, check to ascertain that the Carbon

Brush is in position.

Fig. A-1

NOTE

(Fig. B-1)

FPC Holder

FPC Drum

FPC Cap

Figure in the opposite direction

(Fig. A-1-1)