Specifications

Remote Control
12. MUTE - For a Zenith TV or other brand you
have programmed the remote to operate, press to
turn the sound coming from your TV off, press
again to restore the sound.
13. SEQ -- Some Zenith TVs have audio circuits
that will be operated with this key.
14. SEARCH -- Use to advance or rewind a
recorded tape to an indexed position.
15. TV/VCR -- A change key. Press to change be-
tween TV and VCR tuners to show broadcast
programs on the TV screen.
16. TIMER - Press when all program recording
information has been entered. This will turn off
the VCR until the program time arrives. (After
the program has been recorded, press again to
release VCR from Timer Mode.) Note: Once the
VCR is in the Timer Mode the TIMER key must
be pressed to release the VCR from Timer Mode.
17. F FWD-- Press to advance tape.
18. PAUSE - Press to momentarily cease VCR
record functions or to obtain a still picture while
playing a tape.
19. PLAY - Press to begin playing a tape.
20. STOP -. Press to stop playing or recording a
tape.
21. REW -- Press to rewind tape.
2:2. RECORD -- Press and hold down until
REC CH and the channel number you are record-
ing appear in the VCR message center to start
recording on a tape.
2!3. MEMORY -- Use with the tape counter to ac-
cess locations on recorded tapes.
24. AM/PM - Use to enter AM or PM where re-
quire&
2!5. LEARN - Other product's codes can be
learned by this remote control; use the numbered
buttons and this key to enter the information
necessary to program the MBR3429 remote to
operate your cable box and TV set.
2613-O
26. VCR PLUS -- Press to display the VCR Plus
Code information on the :IV screen.
27. CH MAP - Press to begin Channel Mapping
procedure or to review Channel Mapped data.
28. ENTER - Press to set entered information.
29. Numbers 0 through 9-- Use the,;e keys to
choose information where applicable. These keys
are also used[ for direct channel access.
Remote Control Battery Compartment
2.
30. SELECT - Use this key to choose information
in the menus and rob-menus, where required.
31. ADd - Press to choose.information where ap-
plicable; also used to manually adjust the tracking.
1. Open battery compartment on the back of the
remote control by using your fingernail to
squeeze the tab lock open.
2. Lift compartment door out and install batteries.
Install two (2) high quality new alkaline AAA
size batteries in the VCR remote control.
Note the positive and negative positions for plac-
ing the batteries in the remote control. Once
fresh batteries are installod into the remote con-
trol it is ready for use.
3. Replace compartment door on remote control.
Notes:
Be careful not to place heavy objects on top of
the remote control button_;. Prolonged[ accidental
operation of the remote control will shorten bat-
tery life.
If you do not use the remote control for a month
or more, remove the batteries. Batter)' leakage
can cause damage to the remote control.
Zenith is not responsible', for damage caused by
such battery leakage.
3-2