Specifications

Timer Recording
EP 2E_1112
PLAY STOP
c --_- i[--_--) i
( _ I[--_-- )J
L-SPEED ;_;EARCH'_ I
( " ) I
! P.usE 2
Note: The clock/date must be set correctly to have the program
recorded at the right time.
1. Turn the TV on and tune to channel 3.* (If you
programmed the remote to operate your TV, press 3,
then ENTER.) =See Footnote at the bottom of page 6-1.
2. Change the remote control to VCR mode.
3. Insert a VHS tape into the VCR tape loading compart-
ment. If this is a new tape it will be cued to start at the
beginning; if this is a previously recorded tape, advance
or rewind the tape to the position where you want to
begin recording.
4. Press MENU on the remote control to bring up the Main
Menu (VCR Features). Press 2 to bring up Program
Record. Follow the on-screen instructions, and enter the
recording information for Program 1; check for accuracy
when complete.
5. Enter the information for Program 2; if there is one.
Check Program 2 information for accuracy, etc. Press 3
to bring up Program Review, if needed, to check for
accuracy what you entered for Programs 1 and 2, etc.
6. When programming is complete press TIMER on the
remote control to set the VCR in Timer mode; TIMER
SET' will appear in the V.CR message center. When
recording assignments have been completed TAPING
DONE will appear in the VCR message center. If neces-
sary, press TIMER to release the VCR from Timer mode.
Note: While the VCR is operating in the Timer mode it cannot
be turned on or off manually, and other features available in
modes like PAUSE and STOP, will not be available.
,/ SELECT QUIT
®®®
G ( EITI-'R )
OFF ON
-0
(=D
SOURCE
()
FLASHgI<
CHANNEL
N
YOLU_E
(S=D CZD CZD (_D
CZD OED CS_D C=D
RR.CORO STOP _ S_kRCH
PL_ F FWO "rv/VCR
261_o 9-i