Specifications

I
Playback
L-CHANNELJ
( "It • ;
$P-LP-EP REC IIR
D
,m PLAY STOP
=1 c-_T li _ _ /
/ / REW /FFWD /
//c____ JL____ _ /
iV _SPEED_;E_CH_ I
__ _ / €: ,, ) I
i i=n..-1 / PAUSE /
VRL4170-,4HEAD/_(D
ON SCREEN PROC, RA_G'-I
•
.
3.
°
.
Turn the TV on and tune it to channel 3.* (If you
programmed the remote to operate your TV, press 3,
then ENTER.)
Switch the remote control to VCR mode.
Insert a VHS cassette tape into the VCR loading com-
partment; this turns on the power and the tape will
automatically begin playing if the cassette safety tab has
been removed, or press PLAY on the VCR or the
remote control to start playing the tape.
To stop playing the tape, press STOP on the VCR or
the remote control. Press EJECT on the VCR to eject
the tape.
Note: The symbols shown on this illustration in the
VCR message center will only appear while the VCR is
performing those functions. However, the clock will
remain on while power is supplied to the VCR.
Automatic Reset-The counter resets when you insert a
tape and when a tape is rewound to its beginning.
Display Elapsed Time- Press ENTER on the remote
control; press it again to leave the tape counter display
on the TV screen.
To Remove Counter Display-Press ENTER on the
remote control.
* Or 4, the same channel that you set with the CH 3-4
switch on the back of the VCR to send the VCR signal
to the TV set.
SELECT QUIT
® ®@
® ® ,®
® ® ,®
OFF
-tD
o
CHANNEL
VOLUME
VCR PLUS _4MAP
CS_D C=D
RE:W _ F FWD TV/VCR
.I
_i_o 6 - 1