Specifications

VCR Menu Settings
3. Choose CHANNEL SAVE/SKIP. Each chan-
nel the VCR tuner has found will come up in
numerical sequence. As you press CHANNEL up
choose SKIP to delete any weaker channels as
desired. Choose SAVE to keep the channels with
an adequate signal. Repeat this procedure to
eliminate any other weak channels. For example,
if Channel 27 comes in but is too weak for view-
ing, press ADJ so the word SKIP appears next to
tire weak channel's number. Press QUIT on the
remote control when finished with the Channel
SAVE/SKIP procedure. Now when you press the
CHANNEL Up/Down keys only strong signal
channels will be tuned in and weak ones skipped
using the VCR tuner. Tune channels with a cable
box at the cable box.
Choosing Channels
The remote control must be set to the VCR
mode to choose channels on the VCR. You can
choose a channel by using either the CHANNEL
Up/Down buttons on the VCR or the remote con-
trol, or by using the numbered keys on the
remote control to choose the channel number
directly (32 for example) and pressing ENTER to
switch the VCR Tuner to receive that channel.
The channeI number will be shown in the upper
right hand corner of the VCR on-screen display
which will appear momentarily on your TV
screen each time you change channels or initiate
a VCR operation.
VCR Function On-Screen Display
The TV 4-corner VCR status on-screen display
shows the channel you chose using the VCR
tuner, and also the function the VCR is perform-
ing, PLAY, RECORD, STOP, etc., will be dis-
played on the TV screen for a short time.
T3_pical 4-Corner VCR Status On-Screen Display
STOP-- Indicates the VCR is in the Stop Mode.
SP -- Indicates tape speed is set for Standard
Play.
f
STOP VCR CH 11
SP
15 Mon
7:17 AM 1:35:45
J
VCR CH 11 - Indicates VCR mode is active and
the VCR Tuner is set to Channel 11.
15 Mon- The date the VCR is set aL
7:17 AM - The time the VCR is set at.
1:35:45 -- Tape position :indicator is :at 1 hour, 35
minutes and 45 seconds.
Power Failures
Occasionally a power failure occurs. "]['heresult is
that all the information programmed into the
VCR has to be re-entered'. If you were away
when this occurred and notice that the clock date
and time are missing and :SET CLOCK appears,
then there was an interruption in electrical ser-
vice to your VCR.
Error Messages
As you use the menu system, if a problem or con-
flict occurs the menu system alerts you with an
error message on the TV ,;creen, like "'No Cas-
sette." For example, if you entered all the infor-
mation for a timed recording and pressed the
TIMER key to set the VCR into TIMER Mode
and no tape was loaded :into the tape loading com-
partment, then that error message would appear
on your TV :screen.
261_-o 5-3