Manual

REMOTE CONTROL MODEL LR4455

PREPARATION FOR USE

Batteries are provided _th this remote, but you must install

them before using the remote.

INSTALLING BATTERIES

When the effective operating range of your remote becomes

noticeably shorter, replace the batteries with two high-

quality, alkaline, size AAA batteries.

NOTE: When the remote does not receive power from its

batteries, it may set itself to Zenith video equipment (TV,

Zenith VCR, and Zenith cable-TV decoder) default codes.

If you have "taught" it to operate other equipment, it will

forget what it was taught.

To decrease this possibility, replace the batteries promptly,

and do not remove the old batteries until you are ready to

insert new ones. The batteries normally have enough power

to save the information even if they do not have enough

power to operate the remote.

Remove the battery compartment cover. PUSH

DOWN tab and PULL OUT from top.

Insert new batteries as indicated by the diagram

inside the compartment. Be careful to place the

batteries correctly. If the polarities (the + and -)

are reversed, irreparable damage to the remote

control can occur.

3. Replace the cover by inserting the tab on the bot-

tom of the cover into its housing. Snap the cover

into place.

NOTES:

• Be careful not to place heavy objects on top of the remote

control buttons. Prolonged accidental operation of the

remote control will shorten battery life.

• If you will not use the remote control for a month or more,

remove the batteries. Battery leakage can cause damage

to the remote control.

* Zenith is not responsible for damage caused by such

battery leakage.

lo 1 m

_sl-o 6 - 5