Manual

THE FIRST TIME YOU OPERATE YOUR TV
STEP 1. CONNECT THE POWER
Do not plug "IV into switched outlet on cable-TV decoder.
Plug your TV into an tmswitched AC power source.
The switched AC outlets found on some video equipment
will not continue supplying power to the TV once the equip-
ment is turned off. If the power to the TV is interrupted,
you will have to set the clock in the TV to the current time.
Do not plug TV into svAtched outlet on atVCIL
STEP 2. TURN TV ON
Turn the TV ON by pressing OFF-ON.
STEP 3. SELECT YOUR VIEWING SOURCE
A TV source refers to the equipment connected to the con-
nection center on the back of your TV. For example, anten-
na, cable-TV, VCR, video disc player, etc. You can select
what source supplies the picture and sound to your TV by
pressing SOURCE on your remote control and viewing the
SOURCE MENU.
To Access SOURCE MENU
1. Press SOURCE on the remote control to view the
SOURCE MENU.
2. Press SOURCE repeatedly until the correct antenna or
cable-TV source is highlighted, then press ENTER.
3. Press ENTER again to return to normal viewing.
--SOURCE MENU--
->. ANT/CABLE 1
ANTIC;ABLE 2
VIDEO 1
VII')EO 2
S-VID EO 1
VIDE() 3
S-VIDEO 2
NOTES: The correct antenna or cable-TV sourca._must be
selected before STEP 4 in order for the AUTO CH.
SEARCH to correx's..lyfind available channels
For information about sources, see "Source Menu" section
of this operating guide.
STEP 4. USE AUTO CH. (Channel) SEARCH
When your TV is first powered up, you will see the SETUP
MENU with AUTO CH. SEARCH highlighted. AUTO
CH. SEARCH finds all available channels from the
selected source and stores them in memory for access by
CHANNEL Up/Down. To activate AUTO CH. SEARCH,
press ADJUST (ADJ) Left/Right. When the search is com-
plete, you can watch the TV program of your choice.
NOTES:
1. The SETUP MENU with AUTO CH, SEARCH
highlighted will appear each time you turn on your
TV until AUTO CH. SEARCH has been used at
least once.
2. The AUTO CH. SEARCH message appears only if
one of the ANT/CABLE sources is .,;elected.
3. Your antenna or cable must be connected to the TV
before you use AUTO CH. SEARCH.
(continued on next page)
SETUP MENU
->-AUTO CH. SEARCH
CH. ADD/DEL
CH. LABELS
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAPTIONS
CH. BACKGROUND
PROJO SETUP
START
Setup Menu with Auto Ch. Search Highlighted
2650-0 2 - I