Operating instructions

SETUP MENU
SETUP MENU
•'_ AUTO CH. SEARCH
CH. AOD/DEL
CH. LABELS
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAPTIONS
CH. BACKGROUND
START
SETUP MENU
•.> CL(XT,K SET
CAPTIONS
CH. BACKGROUND
SETUP MENU
SETUP MENU for VIDEO and S-VIDEO SOURCES
AUTO CH. (Channel) SEARCH
Purpose
Finds all available channels and stores them in memory for
access by CHANNEL Up/Down.
Use AUTO CH. SEARCH only when you first install your
TV, or when you permanently change the connections to
the TV. For example, when you replace the antenna with a
cable-TV system.
Before Using AUTO SEARCH
Connect and turn ON all external equipment, such as a
cable-TV decoder, VCR, etc.
NOTE: AUTO CH. SEARCH can only be used with ANT/
CABLE I or 2 source selection.
To Use AUTOSEARCH
1. AUTO CH. SEARCH should be selected if you
followed the "Basic Menu Operation" given in the
"On-Screen Menu" section.
2. Press ADJUST (ADJ) Left/Right to start the
AUTO CH. SEARCH. The status of the search is
shown in the display. When the search is complete,
you can watch the TV program of your choice.
3. Use the AUTO CH. SEARCH feature inde-
pendently for each ANTENNA or CABLE signal
source connected to your TV. Select one source by
using the SOURCE MENU (ANT/CABLE 1 or 2)
and use AUTO CH. SEARCH. When completed,
select the other source and use AUTO CH.
SEARCH again.
When Some Channels Are Not Found
AUTO CH. SEARCH finds only active channels and stores
them in its channel memory. You can add channels to those
stored in memory by using the CH. ADD/DEL option.
If you have difficulty tuning some channels, you may have to
manually change the BAND SELECT and AUTO FINE
TUNE mode. Refer to respective option for details.
NOTE: If the output from a cable box is the input to your
TV, the only active channel will be either 3 or 4.
SETUP MENU
-> AUTO CH. SEARCH
CH. ADD/DEL
CH. LABELS
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAPTIONS
CH. BACKGROUND
START
Selecting Auto Ch. Search
DETERMINING TUNING BAND
Determining
Tuning Band
,,,--4P
TUNING BAND IS
CH 1_1 IS FOUND
J
While Searching for
Active Channels
AUTO Ctt SEARCH HAS COMPLEIE_
TUNING BAND IS
DCHANNELS FOUND
When Search is
Complete
CH2
STEREO
.. J
When Returning to
Channel/Audio Display
2ss0 8 - 1