Operating instructions

GETTING TO KNOW YOUR REMOTE CONTROL

PREPARATION FOR USE

Batteries are providedwith thisremote, butyou must install

them before using the remote.

INSTALLING BA'I-rERIES

When the effective operating range of your remote becomes

noticeably shorter, replace the batteries with two (2) high

quality, alkaline, size AAA batteries. Do the following steps:

1. Remove the battery compartment cover by PUSH-

ING DOWN tab and PULLING OUT from top.

2. Insert new batteries as indicated in the diagram

inside the compartment. Observe proper battery

polarity.

3. Replace the cover by inserting the tab on the bot-

tom of the cover into its housing. Snap the cover

into position.

4. .i_fter installing new batteries, the remote control

will set itself to Zenith brand codes, as follows:

TV = 101, VCR = 201 and CABLE = 301.

If you are going to operate equipment that uses

different codes, the remote must be reprogrammed

for those codes. Refer to "Programming the

Remote Control" section for programming infor-

mation.

CAUTIONS:

• Do not place heavy objects on top of the remote control

buttons. Prolonged accidental operation of the remote

control will shorten battery life.

• If you are not going to use the remote control for a month

or more, remove the batteries. Battery leakage can cause

damage to the remote control.

• Zenith is not responsible for damage caused by such

battery leakage.

11 1

2._ 5-5