Operating instructions

4 200668-02
RANGE
ON-TIMEDUALBRITE™
MAX
D U S K T O
D AW N
T E S T 1 5
(M I N S )
6 3
H R S
O F F
MIN
RANGE
ON-TIME
MAX
TES T 1 5
(M I N S )
MIN
Check Operation and Adjustment
Note: When rst turned on or when switching modes wait 30
seconds.
Locate the RANGE control and ON-TIME control on the motion
sensor:
• The RANGE control and ON-TIME control are located on the bottom
of the motion sensor. Using your ngernails or a small, at-head
screwdriver, gently pry the cover until it opens.
1. Check Operation. Set the ON-TIME control to TEST mode. Walk in
front of motion sensor. The LED indicator light should ash when
motion is detected (see illustration for location of LED light).
2. Adjust Motion Sensor. Turn the RANGE control to the minimum
position (MIN) and ON-TIME control to the TEST position.
Walk through coverage area noting where you are when the
LED begins to ash. Loosen the clamp screw and move the
motion sensor to change the coverage area. Tighten clamp
screw when nished. Do not overtighten clamp screw.
3. Adjust RANGE Control. To increase sensitivity, turn the RANGE
control toward MAX. To decrease sensitivity, turn the RANGE
control toward MIN. Note: If the RANGE is set too high, false
triggering may result in some environments.
Note: When using test mode to check operation in the day time:
A. Set the DETECT control switch to DAY/NIGHT and
B. Set the ON-TIME control to TEST.
4. Set ON-TIME Control. Determine the amount of time you want
the connected device to stay on after motion is detected (1 or
5 minutes). Slide the ON-TIME control to the corresponding
setting.
Du a l Br i t e
®
Dimmer Control
(Model 6032 Only)
IMPORTANT: The Du a l Br i t e
®
control does not function with
the security light receivers. If this sensor will be used with a
security light receiver, the Du a l Br i t e
®
switch should be left in
the OFF position.
The Du a l Br i t e
®
control turns the light on at half power for the
selected amount of time after dusk (Off, 3 or 6 hours, until dawn).
When motion is sensed, the light turns on full power for the selected
ON-TIME (1 or 5 minutes) then returns to accent mode.
1. Select amount of time desired for accent lighting (Du a l Br i t e
®
control).
• Off
• 3 Hours
• 6 Hours
• Dusk to Dawn
IMPORTANT: Avoid aiming motion sensor at:
• Objects that change temperature rapidly, such as heating vents,
fans, and air conditioners. These air sources could cause false
triggering.
• Areas where pets or trafc may trigger the control.
• Nearby large, light colored objects reecting light may trigger the
shut-off feature. Do not point other lights at motion sensor.
51TEST
ON-TIME
(MINUTES)
RANGE
MAX
MIN
180° Motion Sensor Controls - Model 6030
240° Motion Sensor Controls - Model 6032
240° Motion Sensor Controls - Model 6062
LED
Indicator
LED Indicator
LED Indicator
Range
Control
Range
Control
Range
Control
ON-TIME
Control
ON-TIME
Control
ON-TIME
Control