Instruction manual

5
206-4081-C
On the PC
Communication Port Properties
Port: COM1 (Set to available communication port)*
Maximum Speed: 9600 (Required Setting)
Echo: Off (Required Setting)
Data Bits: 8 (Required Setting)
Parity: None (Required Setting)
Stop Bits: 1 (Required Setting)
Flow Control: None (Required Setting)
*May require viewing ports, go to Control Panel: System Properties, Hardware: Device Manager
Click Control Panel >> Open System >> Choose Hardware Tab >> Click Device Manager >> Open Ports
FTG Configuration Application Setup
Setting Up the Application and Communication
Connect a cable between the PC and the FTG card (see page 19).
Execute FTG Configuration Application. (Double click on FTG Configuration Shortcut on Desktop.)
Configure port communications. Click ‘Configure’, then ‘Port Settings’.