Instruction manual

20
206-4081-C
Direct Access Tuning
Once the FTG Channel Map has been stored, the
channels can be accessed using their Logical channel
numbers. This can be done by entering the channel
number followed by the “ENTER/OK”. If the channel
number is not followed by “ENTER/OK”, the channel
will change 2 seconds after the last digit was
pressed. If the number of digits entered is the same
as the number of digits of the highest Logical chan-
nel, the channel change will initiate immediately.
Channel numbers may be preceded by zero(s) and
will be counted as a digit pressed.
Limited Menu
After the FTG card is installed, a limited Function
menu is available to the user. To prevent inadvertent
changes to Setup, Video and Audio Settings, access
to these and other menu items are disabled.
Firm
ware Version
When in FTG mode the FTG card “Banner” will appear
momentarily on the TV screen, the first time the sys-
tem is turned ON after AC power is applied, display-
ing the firmware version.
FTG Card Installer Menu Defaults
The Installer Menu settings listed below are required
for proper FTG card operation and are set by the FTG
card. Any changes made will be overwritten when the
FTG card is installed. Once the FTG card is installed,
the following Installer Menu item settings must not
be changed.
Item Installer Menu Descriptions Preset
00 INSTALLER_SEQ 000
29 OLD_OCV 000
30 ACK_MASK 000
31 POLL_RATE 094
32 TIMING_PULSE 207
47 AUX_STATUS 001
53 DIS_CH_TIME 001
69 EN_CH_T_COL 001
70 FOR_CH_TIME 002
71 BCK_CH_TIME 002
82 CHKSUM_ERROR 001
83 HANDSHK_TIME 005
102 ATSC_BAND 004
FTG Card Features