Service manual

15 PDP 60” - SERVICING
SERVICING
Example below is in NTSC mode.
The values are different for DTV mode:
7. Using the CUSTOMER’S REMOTE, use the channel UP
or DOWN keys to scroll through the menu and the
VOLUME UP or DOWN keys to make the adjustments.
8. To exit the service menu, press the (ENTER) key one
time.
DTV ADJUSTMENTS
9. Press the Channel Up key one time, the following
menu will appear.
HEAT RUN OFF
AUTO CUTOFF
R-CUT 22
G-CUT 8
B-CUT 23
R-GAIN 14
G-GAIN 12
B-GAIN 13
NOTE: “Heat run” has the following settings: OFF, WHITE,
RED, BLUE, and GREEN.
10. These are for warm up of the unit as well as testing
for defects. This function will also remove minor burn-
in on the display. DO NOT USE FOR SETTING RGB
DRIVES.
The following chart shows starting value settings for
adjustments.
NTSC DTV
VP 0 HEATRUN OFF OFF
VP 1 CUTOFF-AUTO
VP 2 R-FINE 16 16
VP 3 G-FINE 16 16
VP 4 B-FINE 16 16
VP 5 R-GAIN 16 16
VP 6 G-GAIN 10 10
VP 7 B-GAIN 3 3
VP 8 R-CUT 151 161
VP 9 G-CUT 94 95
VP 10 B-CUT 25 26
VP 11 (NTSC) DVCO ADJ OFOO
VP 11 (DTV) AUTO PLL END
VP 12
DTV Adjustments
11. Using the CUSTOMER’S REMOTE, use the Channel UP
or DOWN keys to scroll through the menu and the
VOLUME UP or DOWN keys to make the adjustments.
12. To exit this portion of the service menu cycle power
off and on.