Manual

O,E.A,,O.I .E.O,E,O.<,,O.SI PAGE3,
If Programming the Remote did not find your
code, try this procedure to automatically find
the code for your device. If your remote
becomes inoperable, go back to "Programming
your Remote" and enter the Zenith TV code for
step five.
Turn on the device you're
programming for the
remote control.
Press and hoFd-t_PRG k_y unti{
the indicator,light turns on.
Press the key for the device you're
trying to program (CABLE, VCR,
AUX, TV).
Enter the code 0-0-0 (zero-zero-
zero), then press the ENTER key
fight away.
Aim the remote at the correct
device and press the POWER
button. A[{ow a second to pass,
then push the POWER button
again. Repeat until the device
turns off. (This is a trial and error
process, so it may be necessary to
repeat these steps unt]{ the
remote finds your code.)
Push ENrER to save the code.
Press POWERto turn the device
back on. "
Youcon quickly get out of Auto
Find by pressing the Quit button.
If the indicator light stays on
while .you push Power, instead
of turning off, all the codes have
been tried and your device can't
be programmed.
Usethe
remote
controlto
searchat[
possible
codes.
J
3372-0