INSTRUCTION MANUAL

Zenith Firearms | Come Shoot the Quality
11
6. ASSEMBLY
WARNING
Makesurethatthesafetyisonwhileassemblingyourshotgun.
ASSEMBLY OF HAND
GUARD TO BARREL
• Removetheforearm
screwbyturningcounter
clockwise,thenremove
thehandguardby
pulling it gently off the
receiver.
• FortheMC312T,slide
theforwardedgeofthehandguardunderthebarrel,fromreartofront,matingthe
circularopeningtothecircularsteelattachmentsupport.
• Forallothermodels,slidetherearedgeofthehandguardunderthebarrel,from
fronttorear,guidingthesteelattachmentblockintothegrooveuntilitisfully
inserted.
ASSEMBLY OF HAND GUARD AND BARREL TO
THE RECEIVER
•Slidethebarrelandhandguardassemblyover
themagazinetubeuntilthebarrellocksinplacein
theupper.Securewithknurledendcap.Itmaybe
necessarytoadjusttheboltslightlytoensurethe
barrelseatsfully.