Instruction manual

46
INSTALLATION INSTRUCTIONS
BEFORE STARTING
■ This unit is exclusively for use in cars
with a negative ground 12 V power
supply.
■ To prevent short circuits, remove the
key from the ignition and disconnect
the terminal of the battery.
■ Be sure to disconnect the battery
negative terminal before attempting the
installation.
■ Make the proper input and output
cable connections for each unit of the
system.
■ Connect the wiring harness cables
in the following order: ground wire,
battery wire, ignition wire. Connect the
wiring harness connector to the wiring
harness connector on the backside of
the unit.
■ Reconnect the terminal of the battery.
NOTES FOR INSTALLATION
■ Do not connect the yellow wire of this
product directly to the battery terminal.
Do remember to connect the red wire of
this product to the ACC of the ignition
key switch. Failure to do so may result
in draining off the battery prematurely.
■ If the fuse blows, first make sure that
the cables have not caused a short
circuit, then replace the old fuse with
new one with the same rating.
■ Do not let unconnected cables or
terminals touch the metal inside the car
or other metal conductors.
■ To prevent short circuits, do not remove
the caps form unused terminals or from
the ends of the unconnected cables.
■ After the monitor unit is installed, check
whether the brake lamps, blinkers,
wiper, etc. on the vehicle are all working
properly.
■ Insulate unconnected wires with vinyl
tape or other similar material.
PARTS ACCESSORIES
Remote Control (1) Power Cable (1)
PWA 6 X 16 (4) TM 5 X 8 (4)
Manual (1) Trim Ring
KM 5 X 8 (2) Mounting Strap (1)
M5 Nut/Bolt (1) Side Bracket (2)
ZEM-W700DMM Manual E.indd 46 14.01.2005 13:32:26 Uhr