Instruction manual

37
BASIC OPERATIONS
TURNING ON THE POWER
1. Turn on the power
■ Press to turn on the power
2. Mute
■ During Power on, press to mute the
sound.
3. Select the Source
■ Each time you press SRC, the source
changes as follows.
➞ Radio ➞ TV ➞ CDC ➞ RGB IN ➞
AUX IN ➞ AV IN
*Without connecting a DVD/CD changer, you
cannot select “CDC” as the source to play.
4. Adjust Volume
■ Press “-” or “ + ” to reduce or increase
the volume.
5. Adjust the sound as your want
■ Press SEL to select the item you want
to adjust.
Bass ➞ Treble ➞ Balance ➞ Fader.
6. Turn off the power
■ Press and hold to turn off the power.
OPERATING THE LCD PANEL
1. Let the LCD panel come out
■ Press the P.Power button and the
LCD panel comes out and stands up
automatically.
■ When the LCD panel is closed, if there
is a video signal input, the LCD panel
will come out automatically.
■ When the LCD panel is open, if there
is no video signal input, the LCD
panel will be retracted and housed
automatically.
Note:
If the LCD panel stops in the middle
of its operation. Press the P.POWER
button to house the panel and press
the button again to let it come out. The
unit enters the same display mode as
the display was turned off the last time.
2. Adjusting the angle, etc. of the
LCD panel
The angle of the LCD panel or
protruding amount of the panel from
the mounting surface can be adjusted
depending on the mounting angle
of the unit or to cope with (sun)light
coming into the car.
To adjust the angle
■ Every time the ANGLE+/- button on
the remote control or the
5/6 button
on the faceplate is pressed, the LCD
panel tilts forward or backward up to
approx. 15 degrees. The adjusted angle
is stored in the position memory.
ZEM-W700DMM Manual E.indd 37 14.01.2005 13:32:23 Uhr