Instruction manual

29
SAFETY PRECAUTIONS
■ The unit is designed for using with a DC12V, negative ground battery power supply an
may not be connected and/or used differently.
■ Do not operate the unit in any way other than described in this manual. Failure to
follow the instructions will invalidate your warranty.
■ Make sure the monitor does not obstruct or hinder the driver, to avoid the risk of
serious injury and/or traffic accidents.
■ Be careful not to run down the car battery while using the unit! Using this unit
stationary without the engine running may drain the battery, and prevent you from
being able to start the engine later on.
■ Do not disassemble or alter the unit in any way. Any such attempts may result in
damage to the unit and void your warranty.
■ Never clean the surface of the screen with chemical solvent or corrosive detergent,
which may cause permanent damage to the TFT LCD screen.
■ Avoid installing and operating the unit in direct sunlight or near hot air vents. Please
note that the normal working temperature of the unit is between -10°C to 60°C. If
the internal temperature of the vehicle is extremely high, a short cooling down period
is necessary before operating the unit.
■ If the inside of the car is very cold and the monitor is used soon after switching on
the heater, moisture may form on the panel of the unit. Turn off the unit immediately!
Failure to do so may cause the internal components to short-circuit. Allow the unit to
rest for about one hour to allow the condensation to evaporate before operation.
■ In extremely cold environments, the movement of objects in the picture may be
slow and dark. The unit will resume to work normally once it reaches its operating
temperature.
■ The appearance of small black, shiny dots inside the liquid crystal panel is normal.
■ Do not drop or hit the LCD panel with hard objects, as it may cause permanent
damage to the panel. lf you come into contact with any spilled LCD fluid,
wash and clean affected areas with plenty of water and soap and seek medical
attention immediately.
■ Due to different car specifications, please kindly ensure that the monitor is suitably
located and does not obstruct the rear view mirror and air-conditioning vent.
■ Use only the supplied screws to fix the metal mounting plate.
The unit is fully automatic. Do not attempt to adjust the angle of LCD panel or open/
close it by hand as this may cause mechanical and electrical damage.
■ Refer to authorized dealers or the distributor in your country, if you have any queries
about the product.
■ Before installing this unit, please check that you are in compliance with your local
traffic rules and regulations.
ZEM-W700DMM Manual E.indd 29 14.01.2005 13:32:18 Uhr