User manual

38 39
ZE
-
N C 4 612
SYSTEM SETUP: MISC
You may export/import your system
settings to/from a USB flash drive.
A nice feature, to restore your device
settings after a firmware update, or a
complete power disconnection.
Tap "OK" to display corresponding
software version.
Activate password function to
secure device in case of temporary
disconnection from power supply (theft).
Use an arbitrary 4-digit code. To reset
the code enter "0000" instead.
Press "OK" to launch a software update.
For preparations and details, consult the
accompanying update installation
instructions BEFORE you run software
updates.
NOTE:
NOTE:
Help
Calibrate TS OK starts touchscreen calibration
Load factory OK loads factory settings
System settings
Export settings to USB
System settings
Load settings from USB
NOTE:
■ Compare installed software versions with potentially newer versions on
www.zenec.com (see support and download area for updates).
Security
Password enable On, Off
Password
OK sets password
Update Update OK starts software update
Info
Show Info Software
Show Info
BT Software
Show Info
RDS