Instruction manual

10
DEUTSCH
ENGLISH
11
BASIC OPERATIONS
DISPLAY SYSTEM TIME
■ Press and hold the [DISP] key on the front panel to switch the display information
between system time and playing source when the TFT monitor is closed.
USING THE TFT MONITOR
Open/Close monitor
■ Press the [OPEN/CLOSE] key on the front panel or remote control to push the display
panel out or in.
Change the monitor tilt angle
■ Due to the inherent character of LCD panels, you will get different vision impressions
when you watch it from different angles. The display angle of this unit can be changed;
hence you can select the best angle where you can get the best vision impression.
■ Press the [TILT] key on the display panel or the remote control to adjust the tilt angle one
step at a time.
■ Press and hold the [TILT] key on the display panel or the remote control to adjust the tilt
angle continuously.
Change aspect ratio
■ Press the [WlDE] key on the display panel or remote control to adjust the aspect ratio.
lmage setting
1. Enter image setting mode
■ Press the [PIC] key on the remote control.
2. Select one item to adjust
■ Press the []/[] keys on the remote control.
3. Adjust the value
■ Press the []/[] keys on the remote control.
4. Exit image setting mode
■ To exit image setting mode, repeat the rst step or stop operation for some seconds.
RESET THE UNIT
■ lf the unit can not work correctly, you should reset the unit by pressing the [RESET]
button on the front panel.
BASIC OPERATIONS
POWER ON/OFF
■ Press any key on the front panel or the [POWER] key on the remote control to turn on the
power under standby mode. The unit goes back to the last status after power on.
■ Press and hold the [SRC] key on the front panel or press the [POWER] key on the the
remote control to turn off the power under work mode.
NAV
■ Press the [NAV] key on the front panel to enter or exit navigation source. The current
audio channel will keep playing, except the navigation voice comes up when navigation
source is active.
VOLUME ADJUSTMENT
■ Turn the volume knob on the front panel or press the [VOL] key on the remote control.
■ The adjustable range of volume is 0 to 40.
■ Press [VOL] key or mute key on remote to active or deactive [MUTE] function.
 NOTES:
■ Doing the operation above again or adjusting volume wlll release muting.
■ Mute icon blinks on the TFT during muting.
OPEN SOURCE MENU
■ Press the [SRC] key on the front panel or remote control or touch the top left corner of
the screen to open the SOURCE MENU. Do the above operation again to return to the
original source.
PLAYING SOURCE SELECTION
■ Open the SOURCE MENU, and then touch the source you desired or select one source
by moving the cursor and then conrm.
 NOTES:
■ Playing source selection means selecting work mode, such as DVD mode, Radio mode,
Camera mode, etc.
■ When some devices are not ready or connected, they cannot be selected.