Operation Manual

22
This function can be selected using DRC on/off switch in setup menu.
1) Push „SETUP“ button.
2) Move blinking arrow to „DRC“ using „MENU UP“ or „MENU DOWN“ button.
3) Select On or Off using „MENU LEFT“ or „MENU RIGHT“ button.
4) After  nished, push „SETUP“ button again to escape setup window.
When DRC is ON, the high level peaks are reduced with no further effect on reproduction of low
level sounds.
For normal listening, set DRC to off.
4. Pro Logic On/Off
This function makes stereo programs to be reproduced by multiple channels. When this function
is not selected, the original stereo source is bypassed to the front speakers. This function is
automatically bypassed for stereo listening mode, regardless of its selection in setup menu.
To enable or disable Pro Logic, the system should be turned on and:
1) Push „SETUP“ button.
2) Move blinking arrow to „PRO LOGIC“ using „MENU UP“ or „MENU DOWN“ button.
3) Select On or Off using „MENU LEFT“ or „MENU RIGHT“ button.
4) After you are  nished, push the „SETUP“ button again to escape setup window.
5. Crossover Filter Selection
The SUB channel is low-pass  ltered and other channels are high-pass  ltered. The cutoff
frequency of those low pass and high pass  lters is changed simultaneously in this selection. This
selection provides 60Hz to 220Hz of cutoff frequency in 10 Hz steps.
To select suitable crossover  lter to match one‘s own speaker system,
1) Push „SETUP“ button.
2) Using „MENU LEFT“ and „MENU RIGHT“ buttons on the remote control, select cutoff frequency
in decreasing and increasing order respectively. One push of the left or right button makes one
step movement in frequency. The frequency which is selected (displayed) is displayed promptly.
3) After you are  nished, push „SETUP“ button again to escape setup window.
ZE-5.1D Manual E+D 27.02.2004, 14:33 Uhr22