Z-E4626 DEVICE INSTALLATION MANUAL EN
COMPATIBILITY LIST Model Model Version Model Year Mercedes-Benz Sprinter W906 as of 2006 Mercedes-Benz Vito W639 2006 – 2014 Mercedes-Benz Vito W447 as of 2014 Mercedes-Benz Viano W639 2006 – 2014 CAUTION ● The installation of the ZENEC system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect installation can cause damage to the vehicle and the ZENEC system.
EXAMPLE OF INSTALLATION MERCEDES SPRINTER REMOVAL AND PREPARATION 1 2 3 4 1. Gently lift the trim frame out of its plugged anchorage. For successful completion of this step, using a release tool made of plastic tool is mandatory. 2. If your vehicle is equipped with a trim frame including a key panel, unplug the plug of the key panel and put aside. 3. Unscrew and remove the four Torx screws (T25) of the original device. 4. Remove the original device by pulling it out of the radio slot.
6 7 8 9 10 6. Gently lift the panelling out of their plugged anchorage and pull them out. 7. Unscrew and remove the two Torx screws (T25) of the upper tray. 8. Unscrew and remove the four Torx screws (T25) of the heating control panel. Gently lift the control panel. 9. Unscrew and remove the two Torx screws (T25) on the left and right side. 10. Replace the subframe with a manufacturerspecific mounting frame for vehicles with radio or navigation systems.
INSTALLATION: 11. (No picture) Fit the GPS antenna (No. 4) at a suitable place, and make sure that the GPS reception is not adversely affected due to shadowing by metallic vehicle parts (thermal glazing etc.). Use the metal plate supplied as a base for the GPS antenna to improve its reception, depending on the situation. Next run the connecting cable to the radio slot. 12. (No picture) If you wish to use it, now fit the external Bluetooth microphone (No.
16. Connect all the cables to the ZENEC system (No. 1): those previously run in the radio slot, and the original antenna cables. 16 17. Neatly arrange the wires to the side, making room for the ZENEC system. Carefully slide it into the radio slot and fix it in place, using the four original Torx screws (T25). 17 18. Press the trim frame back on to make the installation complete. Please pay attention to reconnect the connectors of the key panel (if available).
CONNECTION DIAGRAM Z-E4626 GPS AM/FM Z-E4626 C D Z-E4626 A1 A3 A5 A7 A9 A11 A13 A15 Z-E4626 A2 A4 A6 A8 A10 A12 A14 A16 Z-E4626 Z-E4626 DAB (see note on DAB antenna page 2) A A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12 A13 A14 A15 A16 E Z-E4626 KL 31 / Power GND KL 30 / Konstant +12V PWR KL 15 / Geschaltet +12V PWR Beleuchtung Geschaltet +12V Amp PWR* Parking Geschaltet +12V Antenne PWR Rückwärtsgang Lautsprecher Hinten Rechts (+) Lautsprecher Vorne Rechts (+) Lautsprecher Hinten Rechts (-) Lautsp
