Operation Manual

58 59
Z
-
E 3 715
MAIN DEVICE SYSTEM SETUP: MISC
You may export/import your system
settings to/from a USB flash drive.
A helpful feature, to restore your device
settings after a software update, reset
or a complete power disconnection.
Display installed Main System software
versions.
Activate password function to
secure device in case of temporary
disconnection from power supply (theft).
Use an arbitrary 4-digit code. The
password code is “0000” by default.
Press "OK" to launch a software update.
For preparation and details, consult the
accompanying update installation
instructions BEFORE you run software
updates.
NOTE:
NOTE:
Name Function Choice/Range
Help
TS Calibrate OK starts touchscreen calibration.
Load factory OK loads factory settings.
System Settings
Export settings to USB.
System Settings
Load settings from USB.
NOTE:
■ Compare installed software versions with potentially newer versions listed
on www.zenec.com.
Security
Password enable On, Off
Password
OK sets password.
Update Update OK starts software update.
Info
Show Info Software
Show Info
BT Software
Show Info
RDS
Show Info
Gracenote