Operation Manual

Using traffic information is enabled by default in the software.
Note!
TMC is not a global service. It may not be available in your country or region. Ask
your local dea
ler for coverage details.
Your device contains the TMC receiver that is needed to receive Traffic events.
If public Traffic data is broadcast at your location, the software automatically takes into
account the traffic events received. You do not need to set anything in the program. The
receiver will automatically search the FM radio stations for TMC data, and the decoded
information will immediately be used in route planning. When your software receives traffic
information that may affect your route, the program will warn you that it is recalculating the
route, and navigation will continue with a new route that is optimal considering the most up-to-
date traffic conditions.
To fine-tune this recalculation, you can set the minimum delay that can trigger a route
recalculation, or you can instruct the software to have you confirm the new recommended
route before it takes effect. You can do these in Traffic settings (page 89).
A special icon (
) is displayed on the Map screen to show you whether traffic events are
received. The icon shows the status of the traffic receiver when there are no traffic events on
your route, otherwise it shows the type of the next traffic event on your route.
Road segments affected by traffic events are displayed with an alternate colour on the map,
and small symbols above the road show the nature of the event:
1. Tap
to open the Traffic Summary screen:
2. Tap
to open the list of of event categories.
3. Tap the traffic category you are interested in, or tap
to see the list
of all events:
83