User's Manual
Table Of Contents
- Device Overview
- Charging and Battery
- Getting Started
- Sensor Flight Mode
- Keeping the Sensor Lens Clean
- Requirements
- Disclaimers
- Responsible Use
- Care and Maintenance
- Changes and Modifications
- Batteries
- Charging
- Prolonged Heat Exposure
- Choking Hazard
- Radio Frequency Radiation Exposure
- Regulatory Information
- Disposal and Recycling
- Disclaimers
- Support
© 2020 Zen-Me Labs Ltd. Zen-Me is patented and trademark of Zen-Me Labs Ltd.
PAGE 10
↑ GO TO CONTENTS
Resetting the Sensor
To reset the sensor, press and hold the Power Button for 30 seconds.
Turn on Flight Mode by tapping the Flight Mode button on the Sensor
Page of the Zen-Me App. Ensure the sensor is within range.
One long ash followed by short, repeated ashes indicates the
sensor is reset and ready for pairing.
3 long (2 second) ashes indicate that Flight Mode is turned on.
Sensor Flight Mode
During Flight Mode your sensor continues to gather data, but does not connect or stream data to your mobile device.
When ying, this ensures your sensor does not interfere with aircra communications systems.
Flight Mode can also be used to save battery power if you are not connecting to your sensor for long periods of time.
Turning on Flight Mode reduces power consumption by shutting down the sensor’s Bluetooth radio functionality. This is automatically
reactivated and connection restored when Flight Mode is turned o.
Go to the Sensor Page at your Prole Page on the Zen-Me App and choose the sensor you want to activate in Flight Mode. Tap the Flight
Mode button on the Sensor Page and follow the sensor lights.
Your sensor will monitor and gather data normally while in Flight Mode. However, you will not be able to connect and stream data from
your sensor before turning Flight Mode o.
NOTICE
Turning on Flight Mode