Operation Manual
30 HD1000-001_v02
Cleaning and maintenance of hair dryer
After each use switch off and unplug the hair dryer.
●
Never put hair dryer, power supply cord or plug in water
●
or any other liquid.
It is recommended to remove from time to time the air
●
inlet cover (2) in order to clean it and the net lter (3),
located under the cover.
When required clean hair dryer casing with a dump cloth
●
(it can be moistened with some washing-up liquid) dry it
out or wipe it till dry.
Do not use scrubbing agents or solvents.
●
Carefully dry all the parts which have been cleaned.
●
CLEANING AIR INLET COVER AND NETLIKE FILTER
(Fig. B)
1
Remove the air inlet cover (2) turning it anticlockwise.
2
Remove the sieve lter (3).
3
Clean it and wipe it using a dry or dump cloth. After
drying place it in the previous place.
4
Afx the air inlet cover (2) turning it clockwise.
STORAGE
If you are not using the appliance always unplug it.
●
After use wait till the hair dryer cools down and place it in
●
a dry, cold and unavailable to children place.
Never turn the cord around hair dryer as it causes the
●
risk of premature wear risk of cord damage. In order to
ensure its long lasting operation the cord is to handled
with care, avoiding tugging, twisting or pulling, especially
when unplugging. If the cord gets twisted during
operation it should be straightened from time to time.
Ecology – Taking care of the environment!
Each user can contribute to protection of environment. It is
neither difcult nor too expensive. To do it:
Cartoon packaging is to be disposed of
as waste paper. Polyethylene (PE) foil
packaging is to be placed in a container for
plastic. Used appliance is to be returned to
a proper collection point, as dangerous parts
of the appliance can cause environmental
hazard.
Do not throw it out together with household garbage!!!
The manufacturer/importer cannot be held responsible for damage
caused by improper use or improper service.
Manufacturer/importer claims the right to modify the product any time,
without prior notice, in order to adjust to law norms and directives or
because of constructional, commercial, esthetic and other reasons.