Operation Manual

28 GW40-005_v02
Dear Customer!
Congratulations on your choice of our appliance, and
welcome among the users of Zelmer products.
Please read these instructions carefully. Pay your special
attention to important safety instructions. Keep this User’s
Guide for future reference.
Safety and proper use instructions
Caution!
Not observance can result in damage to
possessions
Connect the appliance to AC mains supply 230 V
with grounding. You may use an extension cord
(3 conductors) conducting current intensity min. 10 A.
Do not unplug pulling by the cord.
Use the appliance with original thermostat only with
supplying cord and accessories.
Keep the proper space over and around the grill
to provide an easy air ow. Do not let the appliance
touch curtains, wall-paper, cloths, towels or other
combustible materials during operation. Do not use
under cupboards or curtains. Be careful in case of
surface sensitive for heat – thermo isolating pad is
recommended.
Do not place the appliance on or near open re, hot
burner or heated oven.
It is not allowed to use charcoal or similar combustive
materials.
Before usage make sure that grease drip tray and grill
are properly assembled on the base.
Do not use your grill without grease drip tray
assembled.
Fill the grease drip tray with water up to max level, to
reduce smoke emission and make cleaning easier.
Do not move the grill pulling by supplying cord.
Do not let the supplying cord touch hot surfaces.
Use not sharp, the best wooden utensils to turn the
food, in order to avoid scratching non-sticking surface.
In case it is necessary to use sharp utensils and knives,
i.e. to cut something when grilling, at rst remove the
product from the grill.
The appliance is not intended to be operated by
means of an external timer or separate remote-control
system.
In order to avoid any risk posed by an unintentional
return to the initial state of thermal protection, the
equipment is not to be supplied via an external switch,
such as a programmable timer switch, or connected
to the circuit regularly enclosed and disabled by the
power supply.
It s not allowed to cover the heating plate with
aluminium foil, lid, etc, which can result with heat
accumulation and damage plastic parts and the layer.
Do not use aggressive detergents like cream, milk,
paste etc. to clean the casing. They can remove
graphic symbols such as: scales, marking, caution
signs, etc.
Do not wash the parts in dishwasher.
Dry thoroughly after cleaning. Make sure the appliance
is completely dry before thermostat assembling.
EN
Danger! / Warning!
Health hazard
The supplying cord and extension cord can not be in
touch with water or other liquids.
Do not start up the appliance, In case the supplying
cord or housing, thermostat and grill are visibly
damaged. Make a visual inspection before each
start-up.
If the non-detachable part of the cord is damaged,
it should be replaced by the producer or at a proper
service point or by a qualied person in order to avoid
any hazards.
Improper repair can result in serious hazard for a user.
In case of defects we recommend you to contact
qualied service desk.
Place the appliance only at dry, at, rm and heat-
resistant surface.
Do not touch the plug and temperature adjustment
knob with wet hands.
Do not touch hot surfaces.
If necessary to remove the grill, at rst unplug it.
After cooling down, move carrying with handles using
kitchen gloves, as the handles can be still hot. Take
special safety measures!
This appliance can be used by children aged 8 years
and over as well as persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge only if they are properly supervised
or have been given instruction on the safe use of
the appliance and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children unless
aged 8 years and above and properly supervised.
Let the appliance cool down before cleaning or
disassembling.
Always disassemble thermostat before immersing in
water to avoid electric shock.
Do not immerse temperature sensor, supplying cord or
plug neither in water nor in any other liquid.