Operation Manual

63GW33-032_v01
How to use
Attaching accessories
Attach the desired accessory by evenly fastening it to the upper part of the curling iron so that the clip is on the side of the control panel.
You will hear a click when the accessory is properly attached.
Operation
Important!
Keep hot surfaces of the appliance away from skin. Do not touch the heating surface of the appliance.
Heating
1. Unfold the safety support (7). Place the curling iron on the safety support (7), on a at heat-resistant surface. Plug in the appliance.
Switch on the curling iron by pressing the ON/OFF button (1). The control lamp (2) will glow.
2. Set the desired temperature using the temperature adjustment buttons (3, 4). The display will show the following messages for four
different hair types together with the temperature:
FINE ~ 120°C (250°F). –
NORMAL ~ 150°C (300°F). –
THICK ~ 180°C (350°F). –
COARSE ~ 200°C (400°F). –
Wait a few minutes until the appliance reaches the desired temperature (the control lamp will glow with a continuous light).
LCD display
1. After plugging in the appliance and pressing the ON/OFF button (1) the display (5) will show the message "FINE" and the rst stripe
will start to ash. The control lamp (2) will glow with a pulsing light. When the control lamp is ashing, it means that the appliance has
not yet reached the appropriate temperature and is not ready to use. When the appliance reaches the appropriate temperature, you
will hear three beeps and the control lamp (2) will stop ashing and will glow with a continuous light. The stripe will still ash.
2. After pressing the “+” or “–“ button (3, 4) which increase or decrease the temperature, the red control lamp (2) will start ashing again.
This means that the appliance is heating up to the temperature of the appropriate setting (e.g. thick hair). When the appliance reaches
the appropriate temperature, you will hear three beeps and the control lamp (2) will stop ashing. You can start styling your hair.
3. The stripes on the display (5) indicate the time. There are altogether 10 stripes. Each stripe represents 10 minutes.
Example: If the appliance is switched on for 20 minutes, there will be 2 stripes on the display. If the rst stripe does not ash and only
the second one ashes, it means that the appliance is operating for 10-20 minutes.
4. If the appliance continuously operates for 60 minutes, you will hear a few beeps and the appliance will automatically switch off.