Specifications

12 HDVI5 Component Video Switch
13HDVI5 Component Video Switch
1 2 3 4 5 SEL A1 A2
Step 4: Select between Bright and Dim settings: Use SEL button.
Step 5: Adjust Front Intensities.
1 2 3 4 5 SEL A1 A2
Use A1 and A2 to dim and brighten LEDs
A1 = Dim LEDs.
A2 = Brighten LEDs.
Adjusting the Front Panel Intensity
Continued from previous page...
If you have not already done s o, per form Steps 1 and 2 o n the previ-
ous page.
Step 4: Toggle between Bright and Dim Settings
Th e 'SEL' LED i n d i cate s the front panel intensit y settings:
If BLUE LE D i s lit, then t h e B RIGHT level is bein g a d justed.
If RED L E D is lit, then t h e DIM level is bein g a d justed.
Use the 'SEL' bu t ton to tog g l e between bri g h t a n d dim
settings.
Step 5: Adjust Front Panel Intensities
Use the ‘A1’ bu t ton to d e c re a s e the intensit y o f the front
panel lights.
Use the ‘A2’ bu t ton to i n c re a s e the intensit y o f the front
panel lights.
Yo u cannot make t h e DIM level brighter th a n t he BRIGHT
leve l, and you cannot make t h e BRIGHT level dimme r t h an
the DIM level.
Step 6: Use the Power Button to Exit
Once the front panel intensitie s a re a cceptab l e, press the
Powe r button to save the new setti n g s and exit the s e t up
mode.
Note: Th e new intensity sett i n g s are saved in n o n - volatile
memor y and are not affec ted by a power f a i l u re.
•
•
•
•
•
•
Use the SEL button to toggle between
the BRIGHT and DIM settings.
1 2 3 4 5 SEL A1 A2
Step 6: Use the Power Button to Exit.
When things look good, press the
power button to exit setup mode.