Specifications
13
HDS4x2 User Guide, Rev 1.1, 08-31-07
Advanced Control Features
Disabling the IR remote buttons
1 2 3 4 B/A
HDS4x2
To enable or disable the IR remote control buttons:
“Enter the setup mode”, by pressing and holding the power toggle button
1
until the display ashes, or
by pressing
SET
and then on the remote.
Once the front panel is ashing, press the ‘2’ button
2
, or
2
on the remote.
Use the Zone buttons
4
, to scroll to the 02 setting.
Use the Breakaway button
3
, to turn on the RED LED.
Press the Power Toggle button
1
, exit the setup mode and return to normal operations, or continue
onto the next section entitled: “Disabling individual IR remote buttons”.
NOTE: Only the IR remote control buttons are enabled or disabled. This setting has no effect on IR codes
sent through the IR Jack.
Disabling individual IR remote buttons
1 2 3 4 B/A
HDS4x2
To enable / disable individual front panel buttons, start by disabling all the front panel buttons, by performing
‘1’ through ‘4’ of the above steps.
After the front panel is disabled, you can now re-enable individual buttons by selecting the “IR button
enable / disable” mode, by pressing the ‘4’ button
5
. The decimal points on Zones 1 & 2 will light up to
indicate the new mode selection.
Use the Zone buttons
7
to select the number of the IR button you want to enable or disable.
Use the Breakaway button
6
to enable or disable the selected IR button. Turn on the BLUE LED to
enable a button, or turn on the RED LED to disable a button.
Press the Power Toggle button
1
, exit the setup mode and return to normal operations.
The IR buttons are numbered from left to right, top to bottom, as shown in the section entitled: “IR remote but-
ton mapping”, on page 15.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1 2 3 4
Enter / Exit
setup mode
Select “Control settings”
Toggle setting on/off Select setting
1 2 3 4
Enter / Exit
setup mode
Select “Control settings”
Toggle setting on/off Select setting
5 6 7
Select “IR button enable / disable” Mode
Enable / Disable
selected IR button
Select IR
button number
5 6 7
Select “IR button enable / disable” Mode
Enable / Disable
selected IR button
Select IR
button number