Specifications
HDS4x2 User Guide, Rev 1.1, 08-31-07
8
Initial Power On Settings
Changing the initial power on settings
As long as power is applied to the HDS4x2 it will remember its current state when toggled from on to standby
mode, and back to on. However if power is lost (the HDS4x2 is unplugged, or switched off using a power strip,
or a power failure, etc.), the HDS4x2 will power up using its predened settings.
By default, when power is rst applied to the HDS4x2, it powers up in the standby mode, with Zone 1 select-
ed, and both Zones 1 and 2 mapped to Input 1.
These defaults can be easily changed.
1 2 3 4 B/A
HDS4x2
Start by setting the HDS4x2 to the new power on state desired.
For example, the above illustration shows the HDS4x2 turned on, with Zone 1 selected and mapped to Input
1, and Zone 2 unselected and mapped to Input 4.
Once you’ve set the HDS4x2 into the power on state of choice, you can save these settings as the new power
on defaults.
To set new power on defaults using the front panel:
Press and hold the Power Toggle button
1
.
While continuing to hold the Power Toggle button, also press and hold the Breakaway button
2
.
Continue to hold both these buttons until the display ashes quickly 3 times.
To set new power on defaults using the remote control:
On the remote, press the
SET
button followed by the
ON
button.
The display will ash quickly 3 times.
After a power failure, the HDS4x2 will now power up using the new settings.
1.
2.
3.
1.
2.
21
Press and hold the
power toggle button...
...while holding the power toggle,
press and hold the breakaway button
21
Press and hold the
power toggle button...
...while holding the power toggle,
press and hold the breakaway button