Owner`s manual

6
Using Different Remote Codes
Using Alternate Component Keys on your Remote
The HDS4 will also respond to alternate component key codes. Allowing you to use an unused TV,
VCR, RCVR or one of the added AUX positions many remotes include.
Setting up the HDS4 to respond to alternate component codes is a two step process. You must first
program your universal remote control to behave as one of the alternate components. You must
then teach the HDS4 to respond to the alternate component codes.
Programming your remote to different components
The HDS4 will respond to five different pre-programmed component codes, they are: Jerrold Cable
Box, Symphonic TV, Yamaha VCR, Awia DVD and a Nakamichi Receiver. The following table
shows the different component buttons and codes used to program a few different universal re
-
motes.
If your remote control’s model matches one of the above, read your remote’s user manual for in-
structions on programming your remote control, then use the above device and manufacturer codes
to setup your remote.
If your remote is not included above list, or the manufacturer code given does not work, then you
will have to follow your remote controls instructions for programming one of the above components
and search for a proper match. See the next section. Or teach the HDS4 a new set of codes, See:
"Learning New Remote Codes" on page 8.
Teaching the HDS4 a new component code
After your remote control has been programmed to act like one of the 5 built in code-sets, teaching
the HDS4 to use the new code set is simple.
Make Device Sony
One For
All
Sanyo RCA Zenith X10
Jerrold CBL 001 0476 303 046 552 062
Symphonic TV 023 0171 104 189 520 202
Yamaha VCR 040 0038 238 009 025 022
Awia DVD 015 0641 N/A 350 N/A N/A
Nakamichi RCVR 086 N/A N/A N/A N/A N/A