Specifications

16 HDS4.1 Component Video Switch

Step 1: Reset All Parameters to Factory Defaults

1 2 3 4

ZEKTOR

Start by pressing and

holding the Power

button...

...while continuing to hold the Power

button, press and hold both the ‘2’

and the ‘3’ buttons.

After about 4 seconds, the display will ﬂ ash

indicating all parameters have been restored

to their factory programmed values.

5HDS4.1 Component Video Switch

Step 1...

Use the analog input connections to switch component

video / composite video / analog audio or any combination

of the above signals to the HDS4.1’s analog output connec-

tors. Use the digital audio connectors to switch digital au-

dio signals, with full format conversion between the optical

and coax digital audio formats.

Plug the power module into the HDS4.1, and plug the mod-

ule into a standard A.C. wall receptacle. The standby LED

will light up.

Step 2...

To switch between any of the four inputs, simply press

the button for the desired input. If the HDS4.1 is in the

standby, it will turn on. The HDS4.1 will then switch to the

selected input, and the associated LED will light to indicate

this.

To place the HDS4.1 back into the standby mode, press and

release the Power Toggle button. The channel LEDs will all

go blank, and the standby LED will light up. Press the Power

Toggle button again to re-select the previously selected

input.

Step 3...

Use nearly any remote to control your HDS4.1!

Using any remote to operate the HDS4.1 is a simple mat-

ter of pairing up the HDS4.1 with the remote. The remote

doesn’t have to be a universal remote (although it can be),

any remote from an old TV or VCR will work just fine.

Using Zektor’s exclusive Intelligent-IR™, setup is easy! The

HDS4.1 does all the work!

Turn to the next chapter for simple instructions

on how to pair up the HDS4.1 with any remote!

•

Easy, Simple, Instructions!